Memory Unit: Difference between revisions
Jump to navigation
Jump to search
(Created page with '== <span class="mw-headline"> General Information </span> == * Memory Units (64 MB) require no setup or configuration. (Plug & Play) * Xbox 360 accepts two Memory Units. * E…') |
imported>Tuxuser m (Text replace - "Category:Hardware" to "Category:Xbox360_Hardware") |
||
| (5 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
== | {{Cleanup}} | ||
== General Information == | |||
* Memory Units (64 MB) require no setup or configuration. (Plug & | * Memory Units (64 MB) require no setup or configuration. (Plug & Play) | ||
* Xbox 360 accepts two Memory Units. | * Xbox 360 accepts two Memory Units. | ||
* Each unit contains three IC's: | * Each unit contains three IC's: | ||
| Line 7: | Line 8: | ||
# Custom Microsoft ASIC (marked as X805867-002) | # Custom Microsoft ASIC (marked as X805867-002) | ||
# Samsung NAND flash memory (IC model depends on memory size i.e. K9F1208U) | # Samsung NAND flash memory (IC model depends on memory size i.e. K9F1208U) | ||
# Perhaps an | # Perhaps an I<sup>2</sup>C EEPROM memory (marked as X803122) | ||
== <span class="mw-headline"> Known Facts </span> == | == <span class="mw-headline"> Known Facts </span> == | ||
| Line 61: | Line 62: | ||
|} | |} | ||
== | == Speculation == | ||
The connections of the small 8-pin IC: | The connections of the small 8-pin IC: | ||
| Line 73: | Line 74: | ||
901IA2 | 901IA2 | ||
Most plausible theory is that the IC is an | Most plausible theory is that the IC is an I<sup>2</sup>C EEPROM memory. I've added in brackets possible 24CXXX family pin names. GND could be A0 because in most cases adress lines (A0-A2) are connected to ground. | ||
Other theory (less plausible) is that it might be a NXP (Philips) [http://www.nxp.com/pip/P89LPC901_902_903-05.html P89LPC901FD microcontroller] with its die upside down? | Other theory (less plausible) is that it might be a NXP (Philips) [http://www.nxp.com/pip/P89LPC901_902_903-05.html P89LPC901FD microcontroller] with its die upside down? | ||
| Line 79: | Line 80: | ||
When supplying 3.3 volts to the Memory Unit:<br /> Measurements at pins 5, 6, and 7 show that there is a clock signal of 5Mhz present on pin 7 (in burst of 16 cycles).<br /> Every 16 cycles, one bit is transferred on pin 6.<br /> 3ms after powerup data communication ends.<br /> | When supplying 3.3 volts to the Memory Unit:<br /> Measurements at pins 5, 6, and 7 show that there is a clock signal of 5Mhz present on pin 7 (in burst of 16 cycles).<br /> Every 16 cycles, one bit is transferred on pin 6.<br /> 3ms after powerup data communication ends.<br /> | ||
Note: This looks like SPI, pin 7 - SCK, Pin 6 - /SS, Pin 5 - MODI | Note: This looks like SPI, pin 7 - SCK, Pin 6 - /SS, Pin 5 - MODI. | ||
But [http://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus SPI] needs four wires. It's more like I<sup>2</sup>C which needs only two lines (SDA, SCL) and optionally WP (Write Protect). | |||
[[Category:Xbox360_Hardware]] | |||
Latest revision as of 00:24, 7 January 2014
 |
This page needs to be cleaned up, because its either hard to read or contains very little information. You can help Free60 by editing this page and cleaning it up. |
General Information
- Memory Units (64 MB) require no setup or configuration. (Plug & Play)
- Xbox 360 accepts two Memory Units.
- Each unit contains three IC's:
- Custom Microsoft ASIC (marked as X805867-002)
- Samsung NAND flash memory (IC model depends on memory size i.e. K9F1208U)
- Perhaps an I2C EEPROM memory (marked as X803122)
Known Facts
- The Memory card is required in absence of hard drive to play on Xbox Live and to save game progress.
- The memory cards are USB devices, albeit with custom connectors and with 3.3V power (not 5V).
Inside the memory unit
Flash Contents
| Address | Length (bytes) | Contains |
|---|---|---|
| 0x00000 | 16 | Text String "DUMBO FIL format" |
| 0x0020B | 5 | 5 byte value |
| 0x04200 | 32 | MS text string |
| 0x04220 | 15 | Ascii serial nr of MU |
| 0x0440B | 5 | 5 byte value |
| 0x10800 | ~ | Data start |
FATX Partition Locations
| Address | Type |
| 0x00 | Partition 1 |
| 0x7ff000 | Partition 2 |
Speculation
The connections of the small 8-pin IC:
Pin 1: GND (A0)
Pin 2: NC (A1)
Pin 3: NC (A2)
Pin 4: NC (GND)
Pin 5: to pin 22 of ASIC (SDA)
Pin 6: to pins 20 and 21 of ASIC (SCL)
Pin 7: to pin 3 of ASIC (WP)
Pin 8: VCC (3.3V)
At the bottom side of this chip is written:
PHILK2B EL526 901IA2
Most plausible theory is that the IC is an I2C EEPROM memory. I've added in brackets possible 24CXXX family pin names. GND could be A0 because in most cases adress lines (A0-A2) are connected to ground.
Other theory (less plausible) is that it might be a NXP (Philips) P89LPC901FD microcontroller with its die upside down?
When supplying 3.3 volts to the Memory Unit:
Measurements at pins 5, 6, and 7 show that there is a clock signal of 5Mhz present on pin 7 (in burst of 16 cycles).
Every 16 cycles, one bit is transferred on pin 6.
3ms after powerup data communication ends.
Note: This looks like SPI, pin 7 - SCK, Pin 6 - /SS, Pin 5 - MODI.
But SPI needs four wires. It's more like I2C which needs only two lines (SDA, SCL) and optionally WP (Write Protect).