NandCompare
Jump to navigation
Jump to search
General Info
Name: NandCompare
Category: PC Utilities
Version: 1.4
Description: Nand compare & reconstruction tool.
Official Site: http://xboxhacker.net
Creator: User:Rab
Download: [1]
Back to Repository
NFO
nand compare (v1.4): -------------------- i made 6 reads of my nand with no matches (one of them was good but of course i didn't know that at the time), but diffing them i could see that the differences where spread all throughout the file, so i wrote this tool to reconstruct it then i also discovered the usefulness of the compare function in verification of the write, so hopefully this tool will be of use to other people please send feedback, bugs, etc. to rab ([email protected]) or post in the thread on xbox-scene or xboxhacker the tool has two functions: --------------------------- - compare 2 nand images better than simply using md5 as it tells you which blocks are mismatched, which allows you to reread only those that are in error rather than the entire chip (speeding up the process) one use of this is when verifying a write by reading back the nand and comparing it against the original you wrote, if you get a bad block just reread that individual block, patch it into the full read and compare again (files are reread each time you click compare, no need to reselect the same files in the gui) e.g. nandpro lpt: -w16 XBR.bin (write image as normal) nandpro lpt: -r16 verify.bin (read back image) (do comparison, shows block 2e mismatches) nandpro lpt: -r16 2e.bin 2e 1 (read block 2e) nandpro verify.bin: -w16 2e.bin 2e 1 (patch this new read into verify image) (do comparison again, if still bad rewrite just this block and read it back again as above) - reconstruct image from 3 bad reads assumes that read errors don't occur in same place each time, which is true for some read errors (e.g. lpt timing problems), if there is a good reason why you can't read something then this may not be true this tool cannot recreate a nand out of nothing, if you give it 3 files full of zeros you'll get a recreated nand full of zeros, always look at a dump to make sure it looks correct (e.g. has a microsoft copyright at the top, once you've reconstructed a nand open it in 360 flash tool and make sure it reads ok there) the tool works by comparing blocks between the 3 files, any block found matching in 2 (or 3) of the files will be considered good, you will be warned if not all blocks can be recovered, in which case you'll need to get more reads or look for a good reason why your reads are so bad version history: ---------------- 1.4 (2010/01/23) - support any size image (any number of blocks at 0x4000 + ecc) for partial dumps of large nands, 2mb xell backups, etc. 1.3 (2009/12/18) - reduce block size for 256/512mb nands (to 0x4000 + ecc) based on user feedback (nandpro uses small block numbering so our output didn't match up with nandpro) - make gui more responsive when operating on large nands 1.2 (2009/12/15) - support for 256mb nand - use correct block size for 256/512mb nand (0x20000 + ecc) - added progress bar 1.1 (2009/12/13) - support for 512mb nand (assumes same block size as 16mb) 1.0 (2009/12/12) - first release